MT-360 Rechargeable Rotating Field Yoke
Product Characteristics
Magnetic Particle Inspection (MPI) of seam welds and large surfaces with a hand-held yoke is both labor intensive and time consuming. Since the material needs to be magnetized in two directions with overlapping shots, it is possible for the inspector to miss an area. The MT-360 Rechargeable Rotating Field Magnetic Particle Yoke, however, offers an easier solution. This portable yoke can inspect in both directions at the same time with non-magnetic rollers for non-contact inspection. Features an IP 65 dust tight and water resistant design and can be used with any magnetic particle material.
Model:
MT-360(White LED only)
MT-360Z(UV LED and White LED)
Features
- Inspect in Both Directions at the Same Time
- The MT-360 Rotating Field Yoke, magnetizes the material in both directions assuring that longitudinal and transverse flaws are detected. The field direction is alternated at line frequency (50/60 Hz)
- Non-Contact Inspection
- The test is non-contact, non-magnetic rollers create a 0.020” (0.5 mm) gap between the prods and the materials surface, allowing the MT-360 to be rolled across the length of the weld as the inspector applies the magnetic particles.
- Use with Any Magnetic Particle Material
- The MT-360 can be used with wet or dry, visible or fluorescent methods.
- Portable
- The MT-360 is truly portable and easy-to-use. Battery operation permits the use away from AC power supply, so the inspector is not tethered by a power cord
·The probe is powered by lithium battery, and the DC lithium battery inverter AC output can generate AC rotating magnetic field for flaw detection.
·No need of the AC power, improves work efficiency and safety factor; Easy to operate and carry; And it is equipped with a special instrument package, which is particularly suitable for magnetic particle inspection of the internal structure of high-altitude operations, boilers, and pressure vessels.
·The probe is equipped with built-in ultraviolet light and white light, which can be freely installed and replaced during flaw detection.
·Adopting high energy-dense lithium batteries, with sufficient battery capacity and strong endurance; The battery is equipped with an LCD battery indicator, which directly displays the remaining battery power and current voltage value.
·Intelligent no-load automatic recognition and control function, avoiding damage caused by overcurrent and overheating when the instrument is unloaded.
·Adopting adaptive compensation design, the electromagnetic output is maintained in the optimal state to ensure detection sensitivity.
·The instrument meets the technical requirements of JB/T 7411-2012 "Technical Conditions for Electromagnetic Yoke Magnetic Particle Flaw Detectors for Non destructive Testing Instruments" and NB/T47013.4-2015 "Non destructive Testing of Pressure Equipment Part 4: Magnetic Particle Testing".
Standard Components:
MT-360 Yoke : 1
Li Ion Battery : 1
Power Unit - Power Supply/InverterNylon Belt Carrier : 1
Charger : 1
Instrument Package : 1
Aluminum Alloy Instrument Case : 1
Warranty Card : 1
Operation Manual : 1
Certificate of Conformity : 1
- High sensitivity: A1 type 15/100 standard test panel; Clear display of defects
- Large lifting power: ≥ 177N
- Battery size: 208mm (length) * 95mm (width) * 56mm (height)
- Battery weight: 1.2kg
- Probe size: 185mm (length) * 150mm (width) * 170mm (height)
- Probe spacing: 110mm * 110mm
- Probe weight: 3.5kg
- White light illumination: ≥ 1800lux
- UV lamp intensity: ≥ 5800uw/cm ² (MT-360Z only)
- Continuous working time: 4-5 hours
- Power supply: DC 12.6V
- Lithium battery capacity: 11800mAh